Cleaning your Jet Stick Dustbin and Filters

[SamsungMel]

 Please Note: The information on this page is for Australian products only. Models, sequences, error codes or settings will vary depending on location and/or where the product had been purchased. To be redirected to your local support page please click here.

During the process of using your Samsung Jet Stick vacuum to clean your home, the Jet Stick may begin to have a build-up of all the dust, dirt, and anything else it picks. This build-up can decrease the performance of your Jet Stick.

Follow the guide below for cleaning your Jet Stick dustbin and filters.

Note:

• If you notice the display of your Jet Stick lighting up and are unsure what the icons mean, please refer to our Checking your Jet Stick Display page for more information
• For instructions of how to clean the brush of your Jet Stick, please click here
• If you are after information on Replacing the Clean Station Dust Bag, please click here

Cleaning the Dustbin 

1. While the Jet Stick vacuum is turned off, press the dustbin release button, which is signified by the number 1 in the below diagram, and then pull the dustbin down as shown in the picture below

2. Pull the washable micro filter out by holding the filter handles located inside the filter.

3. While pressing the button (1), turn the dustbin cover (2) and remove it from the dustbin (3).

4. Remove the dust from the metal mesh grille filter by using the combination tool.

Note: Do NOT pull the rubber attached to the metal mesh grille filter.

5. After emptying the dustbin, clean the dustbin and filter under running water and leave it to dry in the shade out of direct sunlight.

Tip: With the dustbin upright and a bag over the top, tip the dustbin so the contents fall into the bag to reduce dust clouds.

5. After emptying the dustbin, clean the dustbin and filter under running water and leave it to dry in the shade out of direct sunlight.

Tip: With the dustbin upright and a bag over the top, tip the dustbin so the contents fall into the bag to reduce dust clouds.

7. Put the washable micro filter in the dustbin cover by fitting the groove on the filter first as shown in the picture below.

8. Assemble the dustbin to the vacuum until you hear a click by following the order shown in the picture below.

Cleaning the Filters

Washable Micro Filter:

1. Remove the micro washable filter.

2. Remove any dust and clean with water after removal. It is recommended to clean it about once a month. Be sure to dry your washable micro filter completely in the shade* for 24 hours or more before reassembling for use.

*when heat is applied, product malfunction can occur

Ultra Fine Dust Filter:

1 Detach the ultra fine dust filter by turning it clockwise, and remove any or foreign matter. Then, twist the filter back on.

*When assembling, turn the filter until the line below the lock image is not visible.

If you require further assistance, please consult the user manual from our Manuals & Downloads page or contact our Samsung Care Australia experts on 1300 362 603 (Toll Free in Australia). You can also contact our Chat Support team or reach us through Samsung Members Community.